Group SH 500

Tension wire holder for high loads (supplied without screw)

Your session has expired, please log in again.
SH500
SH/SSH/EKSZ/K
PDF data sheet
  • Base body: glass fibre reinforced polyamide (PA-GF)
moss green RAL 6005
black RAL 9005
traffic grey A RAL 7042
  • The holding holes Ø8-8.1 mm can be recut for upgrading to SH 500 with special thread M9x1.
  • In this case, only custom-made screws with a large flat head and constriction in the shaft for the tension wire can be used - sensible thread: M9x1.

Configure your article. Enter multiple parameters to get the best result.

An error occurred! Please contact our support for help.

Reset filter

Your article results:

  • Please select more filter properties above to get a selection.

Accessories

You might also be interested in