Lamella plug - SRL

Lamella plugs made of PE with strongly curved bottom

Your session has expired, please log in again.
SRL
SRL
PDF data sheet
  • Polyethylene (PE)
black RAL 9005
signal white RAL 9003
traffic grey A RAL 7042
  • Lamellar plugs without specification of the pipe wall thickness are generally suitable for pipe wall thicknesses 1.5 - 2 mm. Please indicate the pipe wall thickness when ordering.
  • The ribs are not suitable for sealing against fluids.
  • The plugs are intended for use in pipes or equivalent bores with free passage corresponding to the clear nominal width of at least shaft length.
  • For technical production reasons, a residual sprue may exceed the shaft length.
  • Material and design of shafts guaranteed stop against drop out and easy assembling.
  • For sufficiently smooth installation in pipes with a greater wall thickness, we recommend chamfering the inside diameter of the pipe (approx. 0.3 - 0.5 x 60°).
  • Depending on the selected article, the surface finish can vary between polished and eroded.
  • The ribs are circularly closed or interrupted.
  • The number of slats per plug varies between 2-4 slats.
  • Special colours (colours, minimum quantities, set-up costs, pricing and surcharges)
  • With your engraved company logo (tooling costs, minimum quantities, set-up costs)
  • With your tampon printed company logo (set-up costs, minimum quantities, printing costs)
  • Most plugs can also be made of suitable harder TPE's (TPE= thermoplastic elastomer --> extended range of operating temperature, noise absorbing, non-skid).
  • The stopper is not suitable for use as a glider
  • As a rule, odd outside pipe diameters rounded to 1/10 mm (as part of the article or order number) indicate that these sizes originate from or are common in the Imperial system.

Configure your article. Enter multiple parameters to get the best result.

An error occurred! Please contact our support for help.

Reset filter

Your article results:

  • Please select more filter properties above to get a selection.

Product variants

You might also be interested in